Once you've got the amount that you need for your sprayer, you're going to remove the lid from the measuring chamber side only. The same thing applies if you didn't get enough the first go around: you can tilt that bottle around again, add some more solution to the reservoir and get it right where you need. Now if you happen to get too much in your measuring reservoir for what you're needing, you want to tilt that bottle back to the left just slightly and allow some of that solution to move back into the tank. Once you've got the correct amount of solution that you need for your label, then you can move on to adding it to your sprayer tank. When you go to measure this, rather than tilting one direction or the other you're going to rotate away from you and around to allow the solution to move from the main chamber of the bottle over into the measuring reservoir. As we start out you can see that the bottle has as most do a measuring reservoir with lines that show you how much solution you may be looking to get for your particular labels needs. but we'll get to that when we move on to the squeezing form. With this particular bottle, we're using as an example with water so there's no seals on this one that we have to worry about. Now, most bottles are going to come with a seal underneath the lid, so you'll want to check for that first. With this design, you're going to start out with the lids on the bottle. We're going to start with the tip and pour because this is the more complicated one and the one that most customers tend to call and email us asking about. We're going to include the standard tip and pour as well as the squeeze and pour. And today i'm going to talk to you and show you how to use some of the various designs of pesticide bottles on the market. ![]() Properly measuring and pouring liquid insecticides can be easy with these step-by-step instructions.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |